Found a stalling issue when run heavy codes on Linuxcnc 2.10.0 TP1
It just stopped in random position without any errors (in terminal as well no errors). But it you press STOP button then run from this line it continue with no problem. With TP0 there is no such error any code up to 1gb run with no problem.
Here is a file I`ve tested:
https://drive.google.com/file/d/1ElRRIED7A49sy2jHRUayxfxAbcnOkvtC/view?usp=sharing
Problem here appeared near at 25% of code running (with default ini settings of planner TP1)
Found a stalling issue when run heavy codes on Linuxcnc 2.10.0 TP1
It just stopped in random position without any errors (in terminal as well no errors). But it you press STOP button then run from this line it continue with no problem. With TP0 there is no such error any code up to 1gb run with no problem.
Here is a file I`ve tested:
https://drive.google.com/file/d/1ElRRIED7A49sy2jHRUayxfxAbcnOkvtC/view?usp=sharing
Problem here appeared near at 25% of code running (with default ini settings of planner TP1)